Backup Camera
Monitor I got on e-Bay.
Edge #98201 license plate frame with back-up camera.
Test of the camera and monitor.
Camera wiring coming into the trunk behind the left tail light.
Old mount for the Edge CTS that is no longer being used.
Dusk shot, license light off. The frame is sitting a tad crooked.
Dusk shot, license light on. The frame blocks the license light.
June 13, 2017
I was going to get a different camera, but decided I'd try and work with what I had; which was some LED strips that were laying around. I figured I'd see if they would work
as a license light when attached to the camera frame. After that, I'll tweak some holes to get the frame sitting straight.
Test with LED strip (6 led, small), and an old license plate.
Test with LED strip (SMD5050, 6 led). This one is a bit brighter than the first one.
Test with LED strip (SMD5050, 6 led).
Test with LED strip (SMD5050, 6 led).
Test with LED strip (SMD5050, 6 led).
June 17, 2017
Frame notched for the wires and the hot glued to hold in place.
Made a "194" adapter to plug into the stock light.
All done.
Reflection of the LED strip in the daylight.
Dusk; lot of light hitting the ground.
Not quite dark out. My inner voice is telling me the light is too bright. I will give
it some time and see how I feel.
October 10, 2017
Got this from e-Bay.
If you have any comments, suggestions, or see any errors, please let me know..... cbradley@telus.net
Last updated on October 10/2018
All contents on this site
are
property of Chris Bradley. No content on this site may be reproduced
without the express permission of Chris Bradley.