Mufflers

---

Borla ProXS mufflers, #40357.




2.25" in/out, center/offset in/out, 14" x 4 "x 9.5" body.




The rattling right muffler.



    
Pretty sure these are the original mufflers.



    
New mufflers welded in place.



    
Old tips welded in place.




Final check for alignment.



    
Almost done. We ran out of time so only got one hanger on each muffler. Will finish it off later in the week.



         
The tips stick out a little further than before; this was planned.




Sounds much better; a deep sound (almost to deep).

Being that the resonator was removed by the previous omwer, I am concerned of "drone" at highway speeds. It is already a little annoying at lower speeds.

---

September 9/14




I noticed a low hangng left tip.




Turns out the rubber wiggled its way off the hanger.




Rubber back in place.




The right side was well on its way.




Rubber back in place.

---

September 25/14




Parts to quiet down the drone of the Borla mufflers.



    
Walker resonator pipe #21383 and gasket #31532.








Overall length is 29".




Overall diameter is 4".




Looking inside the resonator.

---

October 13/14

---

September 4/16

Here are some randome pictures of the exhaust over the past few years.....














    



    
Left side.



    
    
Right side.