Pillar Pod
Generation 3, 3 pod A-pillar pod from ZZP.
Remove the factory A-pillar panel and install the new one. Super simple.
Perfect match on the finish.
I put my Aeroforce in the lower pod (see previous install).
July 2015
I decided to move the Aeroforce to the upper hole. The glare from the windshield made it difficult to see the gauge in the day light. I also covered the holes in the ower pods until I decide what other gauges to get.
VDO hole covers purchased from Jeg's.
Oil Pressure @ Operating Temperature (1850 RPM) Using 10W-30 Oil : 60 psi min
April 13/2018
New gauges from Intellitronix.
Voltmeter, #M9015R, 7.0-25.5 volts.
Oil pressure, #M9114R, 0-99psi.
April 15/2018
Images of where the factory oil pressure sender is.
April 18/2018
Had all the parts needed in my stockpile of brass.
If you have any comments, suggestions, or see any errors, please let me know..... cbradley@telus.net
Last updated on April 21/2018
All contents on this site are
property of Chris Bradley. No content on this site may be reproduced
without the express permission of Chris Bradley.