License Plate
July 10/2019
November 13/2019
February 16/2020
Plate removed; the damage caused by the license plate resting on the paint.
I was worried that the bottom of the plate and frame would rattle or vibrate,
so I stuck them together with some two-sided tape
Put together this from my stash of hardware; couple of bolts (T30, dome head), flat washers and nuts. Trimmed the bolts, then as dab of liquid electrical tape for extra protection.
Had a few more of the bolts, and turns out they were the same thread as the stock ones. Just had to cut them down to length.
Done.
If you have any comments, suggestions, or see any errors, please let me know..... cbradley@telus.net
Last updated on March 29/2020
All contents on this site
are
property of Chris Bradley. No content on this site may be reproduced
without the express permission of Chris Bradley.