I ran down to the recycler's this morning to grab the last two cab mounts that I needed, and I also grabbed two different mounts (these go
in the center of the cab on the Super Duty crew cabs), which will be for my rad support. I spent a few hours on it this afternoon, and got
everything in position. I just need to tighten all the bolts.
Center cab mounts off the Super Duty crew cabs. Not sure what years, but '03 + for sure.
Upper bushing; 2".
Lower bushing; 1 3/8".
Left and right (second from the rear) mounts in place.
Rad support mounts in place. I had to trim down the shoulder a lot, as the
factory hole was narrow and almost oval shaped.
Front and rear finally looking as they should.
If you have any comments, suggestions, or see any errors, please let me know..... cbradley@telus.net
Last updated on October 9/2009
All contents on this site are
property of Chris Bradley. No content on this site may be reproduced
without the express permission of Chris Bradley.